What's the behavior for the command "MVR transmit-filter" ?

Steven_zhang • Created at：Dec 11, 2019 14:31:37 • Updated at：Dec 11, 2019 14:31:44

The basic MVR topology and configuration on the switches as below.
mceclip0.png

Original Behavior: (Not support “transmit-filter” command or “transmit-filter” disabled.)
When the switch enabled MVR function and the status becomes "Active", once the client joins/leaves the multicast group by sending out the report to MVR receiver port.
This report will be forwarded to All the Active Source ports as below.
mceclip1.png
The MVR member of ES3528MV2_SW1 and ES3528MV2_SW2 as below.
mceclip2.png
mceclip3.png

Enabled Transmit-Filter Behavior: (Transmit-filter is disabled on switch by default.)
The mechanism is the same, but this report will not be forwarded to the port which enable transmit-filter as below.
The user could easily configure how the report forward on MVR source ports.
mceclip4.png
The MVR member of ES3528MV2_SW1 and ES3528MV2_SW2 as below.
mceclip5.png
mceclip6.png
Display transmit-filter per port configuration.
mceclip7.png
mceclip8.png

Support models and software version:
ECS4210 series v1.0.0.61
ES3528MV2 v1.5.2.14
ECS3510-28T/52T v1.5.2.14
ES3510MA v1.5.2.14


    Hot articles